PL Mounting Adapter II

$699

Fit: [TERRA with KineMOUNT]

Newly designed PL mounting adapter enables TERRA to support PL lenses right after you mount it on KineMOUNT. It is quite easy and reliable to mount PL adapter to KineMOUNT, just like attaching a PL lens to a PL mount.

PL Mounting Adapter II is lightweight, reliable and supports Cooke i/Technology protocol.

Newly designed PL mounting adapter enables TERRA to support PL lenses right after you mount it on KineMOUNT. It is quite easy and reliable to mount PL adapter to KineMOUNT, just like attaching a PL lens to a PL mount.

There are big improvements on the second generation over previous version:

  1. Support Cooke i/ protocol: the new PL adapter has electronic contacts to support Cooke i/ protocol which can recognize lenses with Cooke i/ protocol and read lens information;
  2. Simple but reliable connection: the new PL mounting adapter matches KineMOUNT perfectly without any cable;
  3. Lightweight: specially designed for TERRA, it weighs only 180g, but still reliable and robust;

To get truly filmic images, choose TERRA with native PL mount or TERRA with KineMOUNT plus PL Mounting Adapter II to use cine lenses.


Attention: Power down camera when swapping different adapters, else camera or adapters may be burned. 

FAQ for PL Mounting Adapter II

Only for TERRA with new KineMOUNT.

Yes, but make sure the rear of the lens is not too long for the adapter.

No, the adapter has internal circuit protection.

NO. This adapter only for new KineMOUNT on TERRA. TERRA with native EF mount should be changed into KineMOUNT before using this adapter. (We charge fee for the mount changing service.)

The FFD is calibrated for new camera with adapter. You need following things to adjust FFD if tuning FFD is needed:
Flange test diagram; The shims for the adapter; A new prime lens or zoom lens; Measuring tape.

First, make sure your TERRA employs KineMOUNT. Caution: KineMOUNT FFD is very short, so install adapters onto KineMOUNT very carefully to prevent anything from touching sensor/OLPF.

Note: Please turn off the camera when you change the adapter, or it may cause serious damage to the mounting adapter even the camera.

    1. Power down: Power down camera at first when remove or install any mounting adapters;
    2. Release: Rotate the locking ring of KineMOUNT in Counter-Clockwise way;
    3. Install the adapter to KineMOUNT: when attaching the mounting adaptor to KineMOUNT, please ensure the two holes in the adaptor match the two pins of KineMOUNT;
    4. Lock: Rotate the locking ring of KineMOUNT to fasten adapter with KineMOUNT firmly in Clockwise way.Power on TERRA after mount the adapter. Press “CONFIG” and check the bottom of this menu, if it presents EF sys 9(or other number), it means you have mounted the adapter successfully.